Trane XR95 Furnace 4 red blinking lights Error Code YouTube

Trane Flash Codes. How to Read Trane Furnace Error Codes by Oleksandr Surdushkin Jan Flashing Red LED - The sensor is not detecting proper temperature, indicating a possible faulty sensor or a wiring issue. Below is a table that outlines the diagnostic flash code meanings for the Trane XR80 furnace: Flash Pattern Meaning; Flashing Slow: Normal - no call for heat: Flashing Fast: Normal - call for heat: Continuous On: Replace control: Continuous Off: Check for power: 2 Flashes: System lockout (no flame) or reversed polarity:

Continuous ON: This suggests replacing the Integrated Furnace Control (IFC). Here are some of the most common codes you might encounter with your trane gas furnace: Flashing Slow: This indicates a normal state with no call for heat

Trane Furnace Led Codes For Trane Furnace

(no vent air flow, bad CBM, closed at an initial call for heat) Flashing 4 times on the red light mainly notifies that the high limit switch has been tripped. (no vent air flow, bad CBM, closed at an initial call for heat)

Igniter relay failure code. Trane TUE1C100A9601AE 5 years old. Reset. Flashing Red LED - The sensor is not detecting proper temperature, indicating a possible faulty sensor or a wiring issue. Read: Why Does Home Thermostat Say HEAT ON But There Is No Heat? Check the electrical components; Inspect the circuit breaker and check the panel for any loose or damaged wires

Trane XR80 Blinking Red Light Furnace Troubleshooting. Slow Flash Rate Normal, call for heat (¾ second on, ¼ second off) 1 Flash : Loss of Communication 2 Flashes: System Lockout: Failed to detect or sustain a flame A system lockout usually occurs after multiple failed attempts to ignite or complete a heating cycle